UV-2600i, UV-2700i - Applications
UV-VIS-NIR Spectrophotometer
Applications
Search
| Applications | Date Creation Date |
|---|---|
2024-01-23 | |
2023-10-24 | |
2023-10-24 | |
2022-10-24 | |
2022-09-28 | |
2022-06-28 | |
2022-06-01 | |
2021-11-26 | |
2021-11-01 | |
2021-06-29 | |
2020-08-04 | |
2020-05-15 | |
2020-03-25 | |
2020-03-05 | |
2017-10-30 | |
2017-10-26 | |
2017-04-03 | |
2016-08-31 | |
2015-07-07 | |
2014-08-01 | |
2013-10-25 | |
2013-08-08 | |
2013-03-24 | |
2012-07-26 | |
2012-06-26 | |
2012-02-06 | |
2012-01-27 | |
Most of the documents on the LITERATURE is available in PDF format. You will need Adobe Acrobat Reader to open and read PDF documents. If you do not already have Acrobat Reader, you can download it free at the Adobe's Website. Click the GET ADOBE READER icon on the left to download a free copy of Adobe Acrobat Reader.
Electricity, Electronics, and Optics
Band Gap Measurements for Compound Semiconductors
The diffuse reflection spectra for two types of compound semiconductors (red line: Culn0.5Ga0.5Se2, blue line: CulnSe2) used as solar cell materials have been measured using the ISR-2600Plus integrating sphere. It is evident that the absorption edge (position where the reflectance drops) differs depending on the sample. This difference signifies a difference in the band gap* for these samples. (The samples were provided by Wada Laboratory, Faculty of Science and Technology, Ryukoku University.) The band gaps for the samples were calculated utilizing the Tauc method. The results obtained were 1.27 eV for Culn0.5Ga0.5Se2 (red line) and 0.99 eV for CulnSe2 (blue line). * The term band gap refers to the energy difference between the top of the valence band, which is full of electrons, and the bottom of the conduction band, which does not contain electrons.
Construction
Window Glass Transmission Measurements
Two types of window glass were measured utilizing the ISR-2600Plus integrating sphere. The sample shown by the red line is highly transparent to near-infrared light at 800 nm or more. The sample shown by the blue line, however, is apparently not very transparent to near-infrared light.
Chemicals
Thickness Measurements of Cling Films
Undulating interference waveforms sometimes occur if light is passed through a film. The film thickness of a sample can be determined by using these interference waveforms. The figure shows transmittance data for a cling film. A clear interference waveform is produced. Utilizing optional film thickness measurement software, the film thickness is calculated as 10.4 μm. (Caution) The sample's refractive index must be entered for the film thickness calculation.
Textiles
Total Transmittance Spectrum of CNF
An ISR-2600Plus integrating sphere was used to measure the total transmittance spectrum of cellulose nanofiber (CNF). Depending on the raw materials used, spectra can vary, transparency can vary, and spectral tendencies in the ultraviolet region can vary.
Life Sciences
DNA and Protein Measurements
The red and blue lines are the absorption spectra for dsDNA and BSA (bovine serum albumin), respectively.
The concentration values are 45 ng/μL for dsDNA and 2.2 mg/mL for BSA.
Foods
Vitamin Measurements
This shows the absorption spectra for riboflavin (vitamin B2).
The sample concentrations are, in order from the highest absorbance, 0.08,
0.04, 0.02, and 0.01 mg/mL.